Power over Ethernet (PoE) Commands
727
OL-32830-01 Command Line Interface Reference Guide
36
Parameters
pd-type—Enters a comment or a description to assist in recognizing the type of
the powered device attached to this interface. (Length: 1–24 characters)
Default Configuration
There is no description.
Command Mode
Interface (Ethernet) Configuration mode
Example
The following example adds the description ‘ip phone’ of the device connected to
port 4.
switchxxxxxx(config)#
interface
gi1
4
switchxxxxxx(config-if)#
power inline powered-device
ip_phone
36.5 power inline priority
To configure the interface inline power management priority, use the power inline
priority Interface Configuration (Ethernet) mode command. To restore the default
configuration, use the no form of this command.
Syntax
power inline priority
{critical | high | low}
no power inline priority
Parameters
•
critical—Specifies that the powered device operation is critical.
•
high—Specifies that the powered device operation is high priority.
•
low—Specifies that the powered device operation is low priority.
Default Configuration
The default configuration is set to low priority.
Summary of Contents for 300 Series
Page 2: ......
