Connecting Cables 4-9
Connecting Hubs
Step 7
Power ON the Cisco RPS. There is one power switch for each AC input power
module. Make sure the power switch is ON (|) for each AC power module used.
(See Figure 4-7.)
Figure 4-7
Powering ON the Cisco RPS
The Cisco RPS provides power in 10 to 15 seconds. The Cisco RPS is working
properly when all its front-panel LEDs are solid green. If the external device
does not power up, refer to Appendix B, “Troubleshooting the Cisco RPS.”
Step 8
If you are using the redundant-with-reboot configuration, press the power switch
on the hub to the ON (|) position to begin providing power simultaneously with
the Cisco RPS.
H9700
rps4 Page 9 Monday, September 14, 1998 8:19 AM
