VCC-5CL1R
Rev. 905-0022-02
©2015 CIS Corporation. All rights reserved.
30
13.
Sequence Control Function
□
This is a function to select one set of parameter out of the preset several parameter sets and apply it to the camera.
□
The maximum 8 sets of parameter can be set in advance. The following parameters can be set per parameter set.
Settable parameter
：
Shutter setting, Gain setting, ROI start position (X,Y coordinate), Horizontal size, and Vertical size
□
Operation sequence is specified as "Index". Specify the parameter set number to be applied for the maximum 8 indexes.
□
There are two control modes; Auto mode and CC mode.
□
When using Sequence Control function, the following operational modes shall be set in advance.
¾
Trigger Shutter Mode: Fixed Shutter Mode or Pulse Width Trigger Shutter Mode. (Normal Shutter Mode is prohibited.)
¾
Vertical Partial Mode: To be invalid for the operation with the Sequence Control setting.
¾
Horizontal Partial Mode: The maximum pixel number used by Sequence Control shall be set.
¾
Binning Mode: OFF
¾
Defective Pixel Correction: OFF
¾
Shading Correction: OFF
□
Note for Timing
¾
The limitation of the trigger input timing at Sequence Control is the same as the one at Normal Mode.
(Refer to the Section 7.9 and Section 7.10.)
¾
The signal level of CC2~4 signals have to be stable by the time of trigger input. (setup time = 50[ns])
