Cirris Signature 1000M, User Manual

Page: 28 / 66

Section 6: Retrieve a Cable from Memory / How to retrieve a cable
1000M User’s Guide / page 28
lyzer prompts the signature for the cable stored in permanent memory location
number 1 (there are 40 of these). Continue pressing
Advance Display
until you
see the signature for the kind of cable you want to test.
4. When the display prompts the signature for the kind of cable you want to test,
release the
Memory
button.
• If the display prompts
Ready To Test
, the analyzer has retrieved the
Sample Cable data, the correct adapters are in place, and you are ready
to test cables.
• If the display prompts
JX Adapter Sig: Should Be
, this means that
the adapters you have installed don’t go with the Sample Cable you’ve
retrieved. Read the display to get the correct adapters and their
positions, then install them.
Note
: It’s OK to install adapters without
turning off the analyzer when it is in this mode. Once you’ve installed
the correct adapters, the display will prompt
Ready To Test
.
MEM LOCATION X
SIG:XXXXXX
Continue to hold...
...while you step through the cable signatures
READY TO TEST
SIG:BBF038-0501
J1 ADAPTER SIG:
SHOULD BE ACEFA1
Cable retrieved, adapters are
correct. You are ready to test.
Installed adapters are not correct.
Install correct adapters. When
you’ve done that, prompt will
change to
Ready to Test
.