Circutor line-LM20I-TCP kit, Instruction Manual

Page: 20 / 112

20
line-M
Instruction Manual
4�4�1�4�- Input signal logic
Note:
Screen visible if the selected operating mode is a pulse input,
STATUS �
This screen enables configuration of input signal operating logic.
SETUP SLOT1
INPUT LOGIC
POSITIVE
D IN1
Hold down key to set the
operating logic
(INPUT LOGIC)
�
Use keys and to skip through the different options:
POSITIVE, Positive logic, a high signal input shows 1 and a low signal input shows 0.
NEGATIVE,
Negative logic, a high signal input shows 0 and a low signal input shows 1.
To validate the option, hold down key .
Use key to skip to the next programming point.
4�4�2�- CONFIGURATION OF RELAY OUTPUTS 1 ��� 4
Note: Configuration of relay output x is shown by the literal D OUTx at the bottom centre of the display.
4�4�2�1�- Variable
This screen enables configuration of the
relay output variable
(VARIABLE)
.
SETUP
SLOT1
VARIABLE
D OUT1
1
V1
Hold down key to enter programming mode.
Use keys and to modify the digit's value.
Press key to skip through the digits.
The codes for the variables are shown in
Table 9, Table 10, Table 11 and Table 12�
To validate the option, hold down key .
Use key to skip to the next programming point.