-- Supply network analyzer CVM-144 (HAR) ----- User's manual --- Page No. 33
- For accessing to the next option, press "
": set-up options for the second
relay will appear.
OUT 2
RELAY 2
CODE
00
(
Parameter value (2)
Act as before. Pressing again "
" the set-up mode is exited.
b.
-
ALARM conditions
(1 condition for each relay): If any other parameter (excepts
for energies) is selected at (1), two outputs can be configured as alarms. For each
output it is possible to set:
c
Any of the parameters measured by the CVM-144
d
MAXIMUM value
e
MINIMUM value
f
Delay for the conditions
These screens are successively displayed by the CVM-144 once the
parameter has been selected ( for the set-up of each option proceed as in the
Section a.-):
b.1.- Programming the maximum value to be controlled:
OUT 1
RELAY 1
AL hI
0.000
(
Maximum value
The key "
max
" will increase the value of the blinking digit (0,1...9, sign -- ). Use
the key "
min
" to pass to the following digit.
