Circutor CEM-C31-485-DS, Instruction Manual

Page: 26 / 58

Tabla 13 (Continuation) : Partial energy screens (Table 2)�
Screen Parameters
COST PAR T1
Cost of the partial active energy consumed Tariff 1
(since the last partial reset )
(13)
kgC0
2
PAR T1
CO
2
emissions into the atmosphere Tariff 1
(since the last partial reset )
(13)
HOURS PAR T2
Hours in partial operation Tariff 2.
(since the last partial reset )
COST PAR T2
Cost of the partial active energy consumed Tariff 2
(since the last partial reset )
(13)
kgC0
2
PAR T2
CO
2
emissions into the atmosphere Tariff 2
(since the last partial reset )
(13)
(11)
The tariff option for the CEM-C31-485-DS model can be configured in section
“6.2.3.- DIGITAL INPUT
TYPE”
(
12)
Only displayed if the reactive energy display option has been selected in the setup menu (see
“ 6.2.7.2. REACTIVE ENERGY DISPLAY”
).
(13)
Only displayed if the efficiency factors display option has been selected in the setup menu (see
“ 6�2�7�3� EFFICIENCY FACTORS DISPLAY”
).
5.5.- IMPULSE COUNT DISPLAY ( CEM-C31-485-DS )
Note:
The impulse count display screens are only visible if the impulse count option has been
configured in the CEM-C31-485-DS model.
To access the pulse count screens, press the key for a prolonged time on the screen in
standby mode. Short presses will display the initial impulse count screen,
Figure 14
:
Figure 14: Main impulse count screen�
26
CEM-C31
Instruction Manual