CIMCO OXE Diesel 125 HP, Installation Manual

Page: 26 / 84

26
OXE 125/150/175/200 HP INSTALLATION MANUAL
MOUNTING THE OXE OUTBOARD
1.
After determining the transom mount position, mark the preferrable mount
hole positions on the boat transom. Drill mount holes, 13 mm (0.5 in)
perpendicular to boat transom.
NOTE! Use OXE installation bolts or equivalent, 10.9 grade.
NOTE!
During sea trailing, 4 bolts (2 on each side) are required. When one ultimate
height has been established, install a a totall of 6 bolts. 2 upper and 1 lower on
each side.
Apply marine sealer to the shanks of the bolts, not the threads! Secure the
outboard with supplied mounting hardware.
!
WARNING
No free play is allowed between transom surface and clamp bracket. The
clamp bracket or transom could break.
2.
Apply marine sealer to the mounting holes and under the washers.
3.
Tighten mounting bolts at a suitable torque suited for the transom material.
First tighten the inner nut, followed by the outer nut. The outer nut will act as
a locknut.