CIMCO OXE Diesel 125 HP, Installation Manual

Page: 55 / 84

55
OXE 125/150/175/200 HP INSTALLATION MANUAL
REFERENCE, INSTALLATION WIRING G3.5
NOTE! Only Cimco Marine approved components are permitted to be connected to
the internal CAN-Bus.
1) Open loop at delivery.
In order to activate ignition, e.g. start the engine, the kill cord switch must be
connected.
Open loop = engine shut-off.
2)
If used, the user ignition signal 1A fuse must be installed and the GND cable must be
wired to the engine’s ground battery.
3) ATO 1A fuse, used only in single engine application. No other supply to the main
NMEA2000 CAN-bus is permitted!
4) Use this NMEA2000 connector to connect your external equipment such as GPS, VHF,
plotter etc. to the 7” display.
If a 3,5” display is used, a completely separate NMEA2000 bus must be used.
5) The 7” display is optional and replaces the 3,5” display.
One display per engine, up to three engines.
6) The 3.5” display is standard equipment, one display per engine.
7)
Used in combination with 7” display only.
8) Use two separate single channel (SPST) switches or one dual-channel switch.
9) Use a 100A fuse on the control supply cable.
10)
Use a 350A fuse on the starter supply cable.
11) Connection point for Dual Station application. Refer to section Dual station for
different OXE outboard applications.
12) Refer to section Controlhead throttle and shift behavior .
Color codes, cable harness
Helm harness
Common I/O harness
Power cables
Customer specific
INSTALLATION WIRING