CIMCO OXE Diesel 125 HP, Installation Manual

Page: 79 / 84

79
OXE 125/150/175/200 HP INSTALLATION MANUAL
SEA TRIAL CHECKLIST (SAT)
Prepare by taking the time to read the Break-in section for the OXE diesel outboard in the installation manual
before sea trialing, failing to follow the procedure could shorten the life of the OXE or void warranty.
Idle/low speed checklist
Engine idle speed - record at the bottom of this form section. Factory set idle speed 850 rpm RPM
Engine oil pressure KPa
Gearbox oil pressure KPa
Engine coolant operating temperature ° C
Voltage at idle V
Fuel pressure at idle MPa
Verify seawater circulation (tell-tale)
Check for fuel/oil/water/exhaust leaks, use caution around moving parts.
Trim function
Steering function
WOT/high speed
Factory recommended W.O.T rpm target 4200 +/-100 rpm
Engine oil pressure KPa
Gearbox oil pressure KPa
Fuel pressure at WOT MPa
Engine Coolant operating temperature WOT ° C
Intake air temperature WOT ° C
Voltage WOT V
Engine rpm Idle WOT
#1
#2
#3
#4
Maximum speed
Knot
Cruise speed/cruise rpm Knot RPM
Trim level at maximum speed %
Propeller selection
Make, model, material
Sea trial condition notes
Ex: seastate, wind, ambient temp, seawater temp.
Sea trail approved by/inspector signature
_____________________________________________
_____________________________________________
Name of signee
Commissioning agent signature
_____________________________________________
_____________________________________________
Name of signee
SEA TRIAL CHECKLIST (SAT)
Please send this form to warranty@oxe-diesel.com.