Ciena 170-3930-900, Hardware Installation And Start-Up Manual

Page: 25 / 104

Installation 2-9
3930 Service Delivery Switch Hardware Installation and Start-up Manual
009-3223-001 Standard Revision E
Copyright
©
2012-2014 Ciena
®
Corporation January 2014
See “Installing a DC Power Supply” on page 2-21 for a procedure.
Transceivers
The faceplate of the 3930 has:
• 8 connections which use 100/1000 Mbps Ethernet pluggable SFP
transceivers.
• 2 connections which use 1 or 10 Gigabit Ethernet pluggable SFP/SFP+
transceivers.
Figure 1-1 on page 1-3 shows the location of these different ports on the
faceplate of the 3930. For more information about the ports see 39XX/51XX
Product Fundamentals .
The SFP/SFP+ modules provide the media-specific portion of an interface,
allowing it to support Ethernet using different media types. One optic module
can be installed into each available port and can be hot swapped.
Figure 2-3
shows a typical pluggable optic module and its parts.
Figure 2-3
Pluggable Optic Modules
Table 2-1
3930 DC Lug Summary
Wire Size Stud Maximum Lug Width Recommended Lug
14 AWG #6 0.31” Panduit PV14-6FF-C (16-14 AWG)
14 and 18 AWG #6 0.31” Panduit PV14-6LF-C (18-14 AWG)
Panduit PV14-6LFW-C (18-14 AWG)
18 AWG #6 0.31” Panduit PV18-6FF-CY (22-16 AWG)
Panduit PV18-6LF-CY (22-18 AWG)
Panduit PV18-6LFW-CY (22-18 AWG)
Note: Use one of these recommended lugs or a close equivalent. If a ring lug is used, you will need to
remove and reinstall the screw. Take care not to lose the screw during this process.
20-pin connector
Bottom of module