CI-340 Operation Manual
CID Bio-Science
1554 NE 3
rd
Ave
Camas, WA 98607, USA
Phone: +1 (360) 833-8835
Fax: +1 (360) 833-1914
[email protected]
www.cid-inc.com
46
TROUBLESHOOTING
If for some reason the instrument is not performing as you expect, please follow these troubleshooting
procedures. If these procedures do not solve the problem, contact the manufacturer or nearest
representative.
Display does not come on . . .
•
Check the battery connection. Make sure the battery is properly inserted.
•
Dead battery. Battery needs to be replaced or recharged.
•
Too much direct light on the display. Pivot or ‘shadow’ the display area such that direct
light does not “blank” out the screen. Excessive glare may be the obvious problem
•
Make sure the accessory cable (if plugged into the CI-340) is in the “OFF” position,
towards the instrument, or simply unplug the cable connector. The switch should only be
in the “ON” position, away from the instrument, when downloading codes from a
computer.
Display does not come on after continuous operation...
•
Check the battery connection. Make sure the battery is properly inserted.
•
Press the EXIT or STOP key to stop any on-going function, or...
•
Press the OFF key to automatically shut off the power, or...
•
Remove the battery, then re-insert.
Display flickers, then goes out . . .
•
Low battery. Battery needs to be replaced or recharged.
•
Check the battery connection. The battery may not be completely installed.
Keys on the keypad do not respond effectively . . .
•
Apply firm pressure to and hold the key(s) until the beep is heard. Multiple keys pressed
(simultaneously) may result in unintentional signal(s) to the microprocessor.
•
Be sure to press the requested key(s) necessary for information to be processed. Any key,
when the unit is powered on, will produce a “beep” sound.
Keypad sound (“beep”) does not respond effectively . . .
Summary of Contents for CI-340
Page 3: ......
