CI-340 Operation Manual
CID Bio-Science
1554 NE 3
rd
Ave
Camas, WA 98607, USA
Phone: +1 (360) 833-8835
Fax: +1 (360) 833-1914
[email protected]
www.cid-inc.com
41
RECHARGING
The CI-340 includes a 7.2V, 3.7Ah Li-ion battery. This battery pack is common among equipment
that utilizes portability (primarily video camcorders). When the battery is fully charged, it will last
for approximately five hours of continuous use. Optional batteries can be used with more operational
time available.
Any one of the following conditions will affect the power supply and the operation of the instrument:
•
Batteries are tested and fully charged when they leave the manufacturer, but they discharge
during shipping and transport.
•
When the battery voltage is below 5.6V, the message “Low Battery” will appear on the screen.
This indication signals an approximate five minutes of use remaining before the instrument shuts
down.
•
When operating the instrument at colder temperatures (below 5
o
C), the battery will diminish in
performance.
Batteries should be fully recharged as soon as possible after use. Storing in a discharged state can
ruin the battery. The batteries should be stored in a cool and dry place, fully charged. Check with the
warranty, manufacturer, or the nearest representative for support if the battery has been damaged or
tampered with.
Rechargeable batteries should be recycled after their useful life. Visit
www.rbrc.org
for more
information on recycling.
TO POWER YOUR CI-340 FROM A LAB POWER SOCKET
Figure 10-1. C
harger
/adapter, power cable and DC
coupler connections.
1.
Connect the DC coupler to the CI-340. Align the front end of the DC coupler with the guides on
the back of the CI-340, then press and slide the DC coupler into the CI-340 to set it in place.
2.
Connect the power cable to the charger/adapter.
3.
Plug the power cable into a lab power socket.
Summary of Contents for CI-340
Page 3: ......
