CIAT VECTIOS POWER IPJ Series, Instruction Manual

Page: 30 / 60

VECTIOS
POWER TM
PJ EN-30
12.2 Stop-drop on the fresh air intake
The stop-drop can be installed on the fresh air intake. It is
recommended in cases where a high moisture content in the
air is foreseen.
The stop-drop (7) is placed after the hood:
●
First, the part (4) is placed inside the hood (1), using 4.8
self-tapping hex screws. If the stop-drop has been ordered
together with the unit, this part will be installed in the factory.
●
Next, the side pro
fi
les (5) are
fi
tted onto the side parts of the
hood (2), each with 2 of the 4.8 self-drilling hex screws.
●
Finally, the pro
fi
le (6) is
fi
tted onto the panel (3). To do this,
unscrew the lower screws on the panel (M6 Allen) and screw
them back on, attaching the pro
fi
le.
12 - FACTORY OPTIONS AND ACCESSORIES
12.1 Dampers hoods
Depending on the assembly chosen, the fresh air and exhaust
air damper hoods are supplied folded down, to be
fi
tted on site
by the installer.
The side parts (2) are supplied screwed to the inside panel (3).
Each part (2) will be screwed to the panel (3) using 3 screws
and to the hood (1) using another 3 screws. These screws are
4.8 self-tapping hex screws and are supplied with the unit.
2 2
3
1
3
2
2
1
3
2
2
4
5
7
6
5
1
Self-tapping hex screws
1
2
3
Important: Always check that the union of two panels using self-
tapping screws is properly secured. The self-tapping screws
must not be unscrewed frequently to prevent any clearance on
the threading.
Caution: the detachment of the hood due to wrong
implementation of the above steps may cause
personal injury and property damage.