CiA TVV420S, Installation And Operating Manual

Page: 22 / 40

- 22 -
Figure 2-12. Sequence PIP Display Setup
4. To set the Sequence PIP mode, use the direction button [ (Left), (Right)] to select
SEQ.
- To select the main screen, use the direction button [ (Up), (Down)] to select MAIN.
- To change the channel, use the direction button [ (Left), (Right)].
In case SEQ PIP mode, the main channel always display and the other channel will be
switching.
5. Press the MENU button to exit the programming mode.
10. Pan/Tilt Setup
These are installed several kinds of Protocol of Rx-receiver or Speed Dome Camera. If
user installs Pan/Tilt Driver or Speed Dome Camera, user has to select the same protocol
name in this menu.
To set the pan/tilt drive, press the MENU button to display the Menu.
- Use the direction button [ (Up), (Down)] to select the Pan/Tilt Setup.
- Press the ENTER button to display the Pan/Tilt Setup menu on the monitor.
Figure 2-13. Pan/Tilt Setup
1. To select Pan/Tilt Driver, use the direction button [ (Up), (Down)].
2. To change ON or OFF, use the direction button [ (Left), (Right)].
!
D-7720B-H1N : Speed Dome Camera
!
CA-PTZ102 : Indoor Pan Tilt Zoom Camera
!
Other : Other Camera
(In Live Mode)
- Push the Pan, Tilt, Focus, Camera Zoom, Pan Auto button
- Push the CH Number
- Push Up/Down/Left/Right button or Shuttle ring to control the Pan/Tilt Driver or
Speed Dome Camera.
Please set the ID Number of Pan Tilt Zoom Camera or Speed Dome Camera as below.
Video Channel ID Number
!
CH1 ---------------------- 001
!
CH2 ---------------------- 002
!
CH3 ---------------------- 003
!
CH4 ---------------------- 004