Chrysler IIIH, Assembly Manual

Page: 74 / 100

Note: Lubricate the windage tray / main cap fasteners
with EF‐411 as directed in Sections 4 and 7 prior to installation
1 Install the windage tray with eight main bearing cap
bolts. Tighten the bolts in the sequence shown to 21 N∙m
(16 ft. lbs.) plus 90°.
2 Align the locator pins (2) to the engine block and install
the oil pump (3) with four bolts (1). Tighten the bolts
to 12N∙m (106 in. lbs.).
3 Install the oil pump chain tensioner on the oil pump.
4 Position the oil pump chain tensioner spring (1) above
the dowel pin (2).
5 Push back the oil pump chain tensioner and insert a
suitable retaining pin (3) such as a 3 mm Allen wrench.
6 Place the oil pump sprocket (4) into the oil pump chain
(3). Align the oil pump sprocket with the oil pump shaft
and install the sprocket. Install the T45 retaining bolt
(2) and tighten to 25 N∙m (18 ft. lbs.).
7 Remove the retaining pin (1). Verify that the oil pump
chain is centered on the tensioner and crankshaft
sprocket.
8 Rotate the crankshaft CW one complete revolution to
verify proper oil pump chain installation.
Revision DRAFT Section 8
Mar‐16 Sheet 14
Long Block Assembly
Windage Tray / Oil Pump