Chrysler IIIH, Assembly Manual

Page: 100 / 100

4 9 Change 17. Set Zero Cut Off Mode to “ON” with the Auto Finish “OFF”.
4 10 Change 28. Set the Auto Finish to “ON”.
4 11 Change Revised Surface Finish limits
4 12 Addition “ Wipe the cylinder bores and piston rings with solvent prior to
performing ring gaps. Ensure the piston rings are clean and all paint
marks are removed.”
5 1 Change Change ultrasonic cleaning solutions to Brulin GD and Brulin QR ‐ DF”
5 2 Change Torque for oil pump shield fasteners
8 2 Change Corrected typo Debris such as RTV sealants, coolant, engine oil, or
cleaning solvents can cause hydraulic locking and aluminum castings to
crank crack when tightening cylinder head fasteners
8 10 Change While maintaining this alignment lubricate the idler sprocket bushing
with EF ‐ 411 clean engine oil and install the sprockets and timing chain
on the engine
9 3 Change Change Isopropyl alcohol from required to recommended
9 4 Change Revised M10 Torque value
9 7 Addition Photo and torque value for vibration damper
9 8 Change Change Isopropyl alcohol from required to recommended
11 1 Change Change ultrasonic cleaning solutions to Brulin GD and Brulin QR ‐ DF”
11 2 Change Change ultrasonic cleaning solutions to Brulin GD and Brulin QR ‐ DF”