10. Using a laser alignment tool and the document referred to in step 5, adjust the horizontal aim
of the speaker.
11. Tighten the bolts on both fixed plates to the torque of 2.1 N*m (19 in*lbf), securing them to
the speaker.
Ensure that the bottom of the brackets are parallel to the platform.
12. Secure the adjustable bracket plates to the platform using appropriately sized lag bolts (not
provided in the box) according to laws and regulations applicable to the venue.
13. Secure the fixed bracket plates to the platform using appropriately sized lag bolts (not
provided in the box) according to laws and regulations applicable to the venue.
Flying the speaker vertically
The speaker is flown, according to installer best practices, using four rigging cables and any legally
required redundant safety cables.
Flying a speaker should only be done by qualified rigging professionals in accordance with local
requirements and regulations.
1. Place the speaker on a flat stable surface in a vertical position.
2. Remove the four pre-installed M10 x 60 mm flat head bolts from the top of the speaker.
3. Insert and screw in the four eye-bolts.
If more downward tilt of the speaker is required, remove two flat head bolts from the top-front
of the speaker, and two from the bottom-rear of the speaker, and insert the eye-bolts into
these holes.
4. Attach the rigging cables to the eye-bolts.
Installation
Christie Vive Audio LS1/LS2 Line Source Speakers User Manual
13
020-102170-01 Rev. 1 (06-2016)
Copyright
©
2016 Christie Digital Systems USA Inc. All rights reserved.
