Installation and Setup
Mirage M Series User Manual
17
020-101942-02 Rev. 1 (10-2018)
Projection lenses, lens mount and other features
The projector includes a motorized lens mount that allows automated lens control and adjustment:
vertical and horizontal offsets, zoom and focus. The projection lens is shipped separately from the
projector. Use the lens cap when transporting the lens to avoid scratching and damaging the lens, which
could affect your displayed image.
E
Input panel
All source connections are made to the input panel located at the back of the
projector. Any of the available optional input cards can be installed in the four
option card slots. The slots are labelled 1 through 4. All option cards have LEDs
to indicate their status.
F
AC receptacle
The AC receptacle is located above the AC receptacle at the back of the
projector. Use this receptacle to plug in an appropriately rated line cord.
G
Kensington lock
Located at the rear of the projector to the left of the AC receptacle, is a
Kensington lock attachment point. This provides the ability to secure the
projector against possible theft.
H
Adjustable feet
Located on the underside of the projector are three adjustable feet. Raise or
lower these feet when positioning the projector to ensure it is level on all sides
so the displayed image appears rectangular without any keystone. For
instructions on how to adjust the projector feet see
I
Rear IR sensor
The two IR sensors receive transmissions from the IR remote from up to 100
feet away. It is important to keep the transmission path to these sensors
unobstructed for uninterrupted communications with the projector. The rear IR
sensor is located at the back of the projector between the status LEDs. The
front IR sensor is located next to the front nameplate.
J
Cooling air vents
There are numerous air vents located around the projector. These vents must
remain unobstructed to allow adequate airflow through the projector and
prevent it from overheating.
http://www.pureglare.com.au
