Installation and Setup
Mirage M Series User Manual
51
020-101942-02 Rev. 1 (10-2018)
3x3 Loop-through wiring solution
Defining the communication method between projectors
In
Configuration
>
Communication
define and control how single or multiple projectors are
linked with each other and with a controlling device. For serial commands see the
M Series Serial
Commands Technical Reference
(P/N 020-100224-XX).
Specifying serial communication parameters
In
Configuration
>
Communication > Serial Options
, configure the following:
•
Baud Rate—
Determines the speed of communication to and from the projector on the RS232
or RS422 links. The maximum rate for the RS232 is 115200; for RS422 it is 19200. Serial
communication is always eight data bits, no parity.
Set the baud rate to match that of your controlling device, such as your PC. Refer to the
documentation for the controlling device to determine the baud rate.
In an existing network of projectors, if you discover a projector has a different baud rate, use
the pull-down list and select the correct baud rate using the
Enter
key. Do not scroll this
control with left or right arrow key.
•
Serial Flow Control—
Determines whether software flow control or no flow control is used
when transmitting and receiving data on the serial port.
•
Projector Address—
Assign a three-digit number (such as 001) or change a number to the
projector currently in use. If the current projector already has a number assigned, that number
appears. Numerical identity for projectors enables you to communicate with a single projector
From
Source
http://www.pureglare.com.au