Installation and Setup
Mirage M Series User Manual
48
020-101942-02 Rev. 1 (10-2018)
value. When setting up tiling of projectors, all projectors in the tile should be set to the worst
case, which is the projector with the highest minimum for the setup.
•
Free Run Frequency—
Sets the output video vertical frequency.
•
Fade To Black Time—
Sets the amount of time (in seconds) it takes to fade the image to and
from black. The on-screen display only allows the fade time to be set. To initiate a Fade to
Black, the Christie Serial command should be used.
•
HDMI Output Loop Source—
Configures the HDMI output options. Selecting
Direct Loop
directly passes the HDMI input signals: on the same Twin HDMI Input Card, the Input1 signal is
looped to Output1 and the Input2 signal is looped to Output2. Selecting
Main/PIP Loop
loops
the Main and PIP video to the outputs, regardless from which card these signals originate. The
Main video signal is looped to Output1 and the PIP video signal is looped to Output2. Selecting
Disable
turns off the HDMI outputs completely.
PIP functionality is disabled in 3D mode.
Connecting tiled projectors
Wiring requirements
A distribution box or digital signal switcher may be used to feed the same video signal to all the
units of the tiling array.
F
IGURE
1-1 U
SE
OF
D
ISTRIBUTION
B
OX
Christie loop-through may be used to set up a tiling array. The system allows wiring (providing the
HDCP requirement is met) when HDCP is used by the source. The cascade level of devices must be
no more than seven levels deep. If single wire loop-through is used, then PIP is not supported.
The wiring diagrams are provided to:
• Meet the HDCP requirement.
(ROW 1, COL 1)
(ROW 1, COL 2)
(ROW 1, COL 3)
From Source
Distribution Box
http://www.pureglare.com.au
