Installation and Setup
Mirage M Series User Manual
21
020-101942-02 Rev. 1 (10-2018)
Installing a projection lens
The projection lens, shipped separately from the projector, must be installed prior to setting up the
projector.
1. Rotate the lens clamp to the open position, as shown.
2. Align the lens interface plate with the lens mount and align the lens electrical connector with
the mating connector on the lens mount.
3. Fully insert the assembly straight into the lens mount opening without turning and press with
your hand as shown.
Warning!
Failure to comply with the following could result in death or serious injury.
• Remove the lens plug from the lens opening in the projector before installing the lens. Retain the
lens plug for projector transportation to protect the optical components from dust and debris.
Notice.
Failure to comply with the following may result in property damage.
• The lens seals the projector, preventing contaminants from entering the interior of the projector.
Never operate a projector without a lens. Remove the rear lens cap from the lens. Keep the front
lens cap on the lens to protect it during installation.
• When installing the lens, ensure that the lens is not inserted at an angle, as this can cause
damage.
LOCKING CLAMP
OPEN
http://www.pureglare.com.au