- 2
-
NOTE ON POWER CORD
AC power cord must meet the requirements of the country where you use the projector.
Confirm the AC plug type with the chart below and a proper AC power cord must be
used.
If the supplied AC power cord does not match your AC outlet, contact your sales dealer.
SETTING-UP PROJECTOR
To POWER CORD
CONNECTOR on your
projector.
Projector side
AC Outlet side
Ground
To the AC Outlet.
(120 V AC)
For Continental Europe
For the U.S.A. and Canada
This projector uses nominal input voltages of 100-120 V or
200-240 V AC and it automatically selects correct input
voltage. It is designed to work with single-phase power
systems having a grounded neutral conductor. To reduce
risk of electrical shock, do not plug into any other type of
power system.
If you are not sure of the type of power being supplied,
consult your authorized dealer or service station.
Connect the projector with all peripheral equipment before
turning it on.
CAUTION
For safety, unplug the AC power cord when the projector is not
in use. When the projector is connected to an outlet with AC
power cord, an appliance is in stand-by mode and consumes a
little electric power.
CONNECTING AC POWER CORD
Connect AC power cord (supplied) to the
projector.
The AC outlet must be near this equipment and
must be easily accessible.
To the AC Outlet.
(200 - 240 V AC)
NAME OF EACH PART OF PROJECTOR
BOTTOM OF CABINET
BACK OF CABINET
FRONT OF CABINET
LAMP COVER
ADJUSTABLE FEET
AND
FEET LOCK LATCHES
This projector is equipped with cooling fans for protecting
from overheating. Pay attention to the followings to
ensure proper ventilation and avoid a possible risk of fire
and malfunction.
●
Do not cover the vent slots.
●
Keep this side clear of any objects. Obstructions may
block cooling the air.
AIR INTAKE VENTS
PROJECTION LENS
✽
SPEAKERS
INFRARED
REMOTE RECEIVER
POWER CORD
CONNECTOR
EXHAUST VENT
TERMINALS
AND CONNECTORS
TOP CONTROLS
AND INDICATORS
INFRARED
REMOTE RECEIVER
CARRYING
HANDLE
AIR INTAKE
VENT
When attaching the PJ-Net organizer
(optional) to the projector, remove the
these parts. Refer to the user's manual
of the optional PJ-Net organizer.
Do not turn on the projector
with the lens cap attached.
High temperature from light
beam may damage the lens
cap and result in fire hazard.
CAUTION
HOT AIR EXHAUSTED !
Air blown from the exhaust vent is hot.
When using or installing the projector,
the following precautions should be
taken.
●
Do not put a flammable object near this
vent.
●
Keep the rear grills at least 3.3’ (1 m)
away from any object, especially from
heat-sensitive objects.
●
Do not touch this area, especially
screws and metallic parts. This area will
become hot when the projector is in
use.
This projector detects internal
temperature and automatically controls
operating power of the cooling fans.
✽
optional