Feeder Line Assembly and Suspension
MODEL C2® Plus & MODEL G™ Plus Feeding System
26
MF1255C
9. At the control unit, after clamping the cable to the spring, cut the cable about 8" to 10"
[200 to 250
mm]
longer than necessary. Feed the end of the cable through the center of the spring, around the
first insulator on the control unit, and clamp the cable using the cable clamp supplied with the
control unit. See
Figure 40
.
10. Install the wire form on the control unit insulators. Be sure the guard snaps into the retainers molded
into the insulators. See
Figure 40.
Figure 40. Anti-Roost Installation at the Control Unit
11. Install the Poultry Trainer or Line Charger, as shown in
Figure 41 or 42
.
The Poultry Trainer is used to power all Anti-Roost lines in a house. See
Figure 41
.
The Line Charger is used to power individual Anti-Roost lines in a house. See
Figure 42
.
Route the charger wire from the Poultry Trainer or Line Charger to the Anti-Roost system. Secure
the Charger Wire to the Anti-Roost cable, using a cable clamp.
Figure 41. Poultry Trainer Installation
1255-90 9/2000
1)
Clamp
2)
Clamp with Anti-Roost Bracket and Insulator
5)
Wire Form
3)
Insulator
4)
Spring should be Stretched
3/4" to 1" [19 mm to 25 mm]
1255-91 9/2000
1)
Secure Poultry
Trainer to the
Wall or Post
2)
Ground Wire
3)
Anti-Roost Wire
4)
Insulated Charger Wire