MODEL C2® Plus & MODEL G™ Plus Feeding System
Feeder Line Assembly and Suspension
MF1255C
25
Anti-Roost Installation
1. Unroll the bulk anti-roost cable. Note: If the cable is unrolled
as shown in
Figure 37
, taking 5 loops of the coil with one
hand, then changing hands to remove 5 loops as it is unrolled,
it will lie flat during installation.
2. Start at the hopper end of the line and form a
loop around the anti-roost bracket. For best
results, make a double loop around the anti-
roost insulator in the center groove of the
insulator and fasten with a 1/16" cable
clamp as shown in
Figure 38.
3. Insert the cable in the insulator on the top of
each Grill Support between the hopper and
the next anti-roost bracket.
4. Attach a spring in the center
groove at the second anti-
roost bracket and cut the
cable at this point. See
Figure 39.
5. Thread the ends of the cable
through the end of the spring.
Pull the cable tight so that
there is 3/4" to 1"
[20 to 25
mm]
of stretch in the spring.
Clamp the cable to form a
loop and cut off any excess.
See
Figure 39
.
6. Attach the cable to the
insulator
.
For best results,
make a double loop around the anti-roost insulator in the center groove of the insulator and fasten
with a 1/16" cable clamp as shown in
Figure 39.
7. Run the cable to the next insulator, attach a spring in the center groove at the anti-roost bracket and
cut the cable at this point. The cable should be positioned in the insulator built into the top of each
grill support along the feeder line.
8. Repeat this installation until the anti-roost cable is installed along the entire feeder line.
Shock2 3/98
Figure 37. Unrolling the Cable
1255-102 9/2000
2)
Clamp with Insulator
Bracket and Insulator
1)
Cable Clamp
3)
Anti-Roost Cable
Figure 38. Anti-Roost Cable at the Hopper
1255-103 9/2000
1)
Cable Clamp
4)
Spring should be stretched
3/4" to 1"
[19 mm to 25 mm]
3)
Anti-Roost Cable
1)
Cable Clamp
2) Clamp with Insulator
Bracket and Insulator
Figure 39. Anti-Roost Cable Mid-Line Connection