Now, select the
Debug
tab and check for the following settings. If different than shown in
figure 28, make the required changes. The most important setting here is the “
Preserve
EEPROM contents when reprogramming device”.
Click on the
Apply
buttons to update the
project file (.
aps
) and then click the
OK
button to continue.
Figure 28: JTAG ICE mkII Debug Settings Window
Since the IEEE address was erased when the program was initially downloaded when
establishing a new project. The address must be restored before debugging or normal
operation begun. Save project and exit debugging. Follow procedure in the section “
Restoring
the IEEE Address of the CC2420DB”.
The next time the same debugging project is reloaded
with AVR Studio the project settings are configured properly.
Chipcon AS
SmartRF
®
CC2420DBK Demonstration Board Kit User Manual
(rev. 1.3) 2004-11-03 Page 41/ 52