Now, select the
Connection
and check for the following settings. If different than shown
below, make the required changes. Since this is a new project, settings for the
Debug
tab
can’t be specified- the microcontroller’s Flash and EEPROM will be erased before the
program is downloaded to Flash. Click on the
OK
button to continue. Please refer to figure 26
for reference.
Figure 26: JTAG ICE mkII Connection Settings
At this point AVR Studio downloads the program into the CC2420DB Atmega128L Flash
memory, graphically showing progress at the bottom of the screen. If successful, the program
counter is reset and AVR Studio enters debugging mode. Completion or error status is shown
in the message box at the bottom of the window.
Chipcon AS
SmartRF
®
CC2420DBK Demonstration Board Kit User Manual
(rev. 1.3) 2004-11-03 Page 39/ 52
