14
via Costituzione 50/D 4201 5 Correggio (RE) Italy - Tel. +39 0522 637224 Fax. +39 0522 631 1 80 [email protected]
REGULATING THE MACHINE
The machine is fully factory tested before being shipped and
therefore no regulations need be made.
When the machine is started for the first time, the compressed
air pressure should be adjusted as follows:
Pull the air pressure regulating knob up to release it.
Turn the knob until the pressure gauge needle is on 5 bar.
Push the knob back down to lock it in this position.
CONTROL AND STATUS INDICATION PANEL
The following devices are found on the control panel:
Main switch with fuse, voltage change jumper, power socket. Control and programming keyboard.
Back-lit liquid crystal display to read current settings and any fault messages.
Built in beeper.
1 ) Start key - starts work cycle (same as start pedal).
2) Stop key- stops work cycle.
3) Program key - when pressed you can select the program number on the number pad.
4) Programming key - (with the access code) is used to modify standard programs.
5) Counter - used to set the number of items to be folded.
6) Total counter - shows the number of items folded since the last reset and the number set. If
pressed twice, it will show total working time and total machine strokes.
7) Shows the hourly production set or, depending on the context, alternates upper case and lower
case.
8) Cancels the last operation executed or, depending on the context, puts a space between two
letters.
9) Number key or, depending on the context, alphanumeric key.
1 0) Confirmation key (Enter)
1 1 ) Liquid crystal display. Displays information or messages on machine operational status.
START UP AND ADJUSTMENTS
1
2
3
4
5
6
7
8
9
1 0
11
Summary of Contents for Speedy T 2005
Page 2: ......
