22
via Costituzione 50/D 4201 5 Correggio (RE) Italy - Tel. +39 0522 637224 Fax. +39 0522 631 1 80 [email protected]
POSITIONING THE GARMENT TO BE
FOLDED
Some basic rules for placing the garment on the work
table must be followed to guarantee good folding
results. To simply matters, let's use a sleeveless article
such as a T-shirt to illustrate these rules.
- Place the T-shirt with the front against the folding table.
- Centre the T-shirt on the table.
- To define the position for the neck, mark a point from
the free edge of blade 5 edge equal to the length of
blade 4. The mark can be made with a strip of paper
adhesive tape on which you can trace the line of the
neck for greater precision in positioning.
REGULATING THE BLADES
When blades are changed, their position will have to be adjusted as needed. The machine is
designed to facilitate a wide range of regulations so that different format blades can be used. Blades
are regulated by screwing the adjusting screws in holes on the front and right panels in or out. The
machine's tool kit includes a special spanner for doing this. Symbols near the holes describe their
functions.
• Always switch the machine off to prevent it from being started by accident.
•Do not force the screws. If, when you turn them in one direction you encounter resistance, try
turning them in the opposite direction (the screw is probably all the way in or out).
The blades should be 5-1 5 mm apart. If they are closer, they can interfere with each other and fold
quality will be less.
Summary of Contents for Speedy T 2005
Page 2: ......
