INST.No.INE-454-P2 Software
Ver.1.2
-18-
4.9.3-2) Zero side data display/setting by IR-CA series
4.9.3-3) Zero side data display/setting by furnace temperature by a reference radiation
thermometer
4. Engineering mode
1) When entering into
[Zero side data display/setting by IR-CA
series],
“
MES.Z
” appears in the sub display
as shown in the
right figure.
Press SEL key in the case of only the confirmation of data and
move to [4.9.3-3) Zero side data display/setting by furnace
temperature by a reference radiation thermometer] screen.
2) By pressing
key, the most significant digit of the main display
will blink
3) Use
or
key to program the desired value.
4) To shift to the next lower digit, press
key.
The next lower digit will blink.
5) Repeat the above procedure of 3) and 4) up to the least
significant digit for programming (4 digits).
6) To activate this programming, press
ENT
key.
1) To enter the zero side data display/setting by furnace
temperature by a reference radiation thermometer, press SEL
key in the [4.9.3-2) Zero side data display/setting by IR-CA
series] screen.
“
SEt.Z
” appears in the sub display
as shown in the right figure.
Press SEL key in the case of only the confirmation of data and
move to [4.9.3-4)
Span side data display/setting by IR-CA
series] screen.
2) By pressing
key, the most significant digit of the main
display will blink
3) Use
or
key to program the desired value.
4) To shift to the next lower digit, press
key.
The next lower digit will blink.
5) Repeat the above procedure of 3) and 4) up to the least
significant digit for programming (4 digits).
6) To activate this programming, press
ENT
key.
Tb CONT MEM PEAK
AL
A
H
C
F
ε
Sub display
Main display
Tb CONT MEM PEAK
AL
AH
C
F
ε
Sub display
Main display
