Instruction Manual
Safe-Keeper
9
CAUTION: Do not over-tighten the U-bolt
. Over tightening the U-bolt may cause difficulty during final
assembly.
e.
Using a wrench, tighten the nuts on each side of the U-bolt ½
turn.
f.
Slide the security shroud over the threaded ends of the U-bolt
until its holes align with the holes in the clamping saddle.
g. Holding the security shroud in place, pass the security cable
through the smaller of the two holes in the security shroud.
h. Snap the Safe-Keeper cable head into the locking hole on the
Safe-Keeper and follow the directions for setting the desired
security level.
i.
Spin combination dials to random setting.
2. CABLE TETHER FOR MOBILE APPLICATIONS
When using the cable to tether for mobile application, make sure the tether can’t be easily removed without disarming the Safe-
Keeper. We suggest arming the Safe-Keeper at Level 1 or Level 2 whenever possible (item is stationary).
3. ATTACHMENT PLATE
The Attachment Plate (see Figure 8) is designed to be attached directly to a projector/display or to a stationary surface from which
you can tether your projector/display. The Attachment Plate may be adhered using adhesive pads or screws.
If using the adhesive pads for permanent mounting of the Attachment Plate, follow these directions:
a.
Select a surface that will allow you to slide the
Safe-Keeper on and off (note direction of travel) of the Attach-
ment Plate.
b. Prepare the surface by wiping with alcohol pad (included).
c.
Peel release paper from adhesive on back of Attachment Plate.
d. Position the arrows on the Attachment Plate in a direction
allowing unrestricted access to mount and dismount the Safe-
Keeper from the desired permanent location.
e.
Press firmly on Attachment Plate for 10 seconds, making sure
the adhesive pads make full contact with the mounting surface.
f.
Wait 24 hours for adhesive to set before sliding
Safe-Keeper on and off the Attachment Plate.
Use the Attachment Plate as follows:
a.
Press and hold Green Trigger button.
b. Slide Safe-Keeper onto Mounting Plate, in direction of arrows,
making sure each hinge on the back of your Safe-Keeper
engages the Mounting Plate.
c.
Release the Green Trigger button (locks Safe-Keeper to
Mounting Plate).
d. Make sure the Safe-Keeper is securely locked on the Mounting
Plate by attempting to slide the Safe-Keeper from the Mount-
ing Plate without pressing the Green Trigger button.
Figure 8
