background image

Safe-Keeper

BEFORE YOU BEGIN                                                                         

WARNING:  Hold security cable during retraction into Safe-Keeper to prevent uncontrolled motion. Uncon-
trolled motion of the cable may cause personal injury.

WARNING:  Loud alarm (110 db), do not hold the Safe-Keeper close to ears when activated.

CAUTION

:  You must fully depress the Green Trigger Button while opening or closing the battery compartment.

CAUTION

:   To maintain security of your Safe-Keeper, rotate the dials on the lock to random numbers after every 

activation or when not in use.

• NOTE:   In some buildings, normal architectural movement may be sufficient to trigger the motion detector.  In 

these cases, or for use in areas where earthquakes are common, we recommend use of the “cable continuity only” 
mode and the Projector Slot Attachment Adapter (see Page 10).

• NOTE:   Battery life expectancy is approximately 6 months.  Frequent activation and testing diminish battery life 

expectancy.  To maintain security, check/replace batteries every 3 to 6 months or when Safe-Keeper indicates low 
battery (see Page 3).

• If you have any questions about these instructions, contact Chief Manufacturing at 1-800-582-6480.

I N S T R U C T I O N       M A N U A L

Congratulations on the purchase of your Safe-Keeper 
security device from Chief Manufacturing and thank you 
for your confidence in our product.

Your Safe-Keeper is designed to give you serious protec-
tion for the security of your projector, display, or presenta-
tion equipment. To obtain the best results from your 
investment, please read this manual and acquaint your-
self with your new purchase before applying this security 
device. This will save you time and minimize the chance 
of inadvertent activation of the device.

You will need this manual for operating and maintenance 
procedures. We suggest that you keep this manual, with 
your combination, in a safe place for future reference.

We suggest you
write your combination here:
for quick reference

LOGO

CHIEF MANUFACTURING INC.

1-800-582-6480

  952-894-6280  FAX 952-894-6918

12800 HIGHWAY 13 SOUTH, SUITE 500

SAVAGE, MINNESOTA 55378  USA

PART NO. 8830-000001  (Rev. D)

2000 Chief Manufacturing

www.chiefmfg.com

Printed in USA  07-15

Summary of Contents for Safe-Keeper












Reviews: