0
Pressing down the locking button on the axle, insert the xc
skiing Kit into the axle socket on the chariot cx until it can go
no further. release the locking button. the axle will now click if
installed fully.
make sure the skis are inserted correctly with the ski tips
towards the front of the carrier.
warning
always check that both ski frames are properly attached
by pulling the ski frame outwards hard without pressing the
axle’s locking button. to do this, lift the carrier slightly and
hold it firm with one hand. Make sure that the ski cannot be
pulled off. Failure to do so could result in the lose of the skis
causing an accident in which your passenger(s) could suffer
serious injury or death.
Fitting the ski arms to the carrier
Identical for all models.
insert each arm into the Versawing 2.0 until the vertical holes
in the arms and Versawing 2.0 are aligned with each other. the
arms should now, at the back in the slot of the Versawing 2.0,
protrude about 2 cm / 3/4“ over the plastic edge.
warning
always make sure that the security pin of the ski arms are
properly inserted to prevent the carrier from accidentally sli-
ding away resulting in an accident in which your passenger(s)
could suffer serious injury or death.
TiP
the holes in the ski arms are larger than the security pins,
so that the arms can rotate slightly around their longitudinal
axes (in order to adapt to narrow or wide hips, and single and
double width carriers).
now secure the arms by inserting the security pin from above
down through the vertical hole in the arm and Versawing 2.0
until it stops. lock the security pin by looping the spring clip
over the pins end that protrudes underneath the Versawing 2.0.
!
!
Summary of Contents for CHEETAH 1
Page 54: ......
