correctly installed hitcharm.
warning
make sure that the hitcharm is correctly attached and se-
cured to the carrier. any kind of incorrect assembly may lead
to loss of the carrier during travel resulting in an accident
in which you and/or your passenger(s) could suffer serious
injury or death.
Attaching the hitcharm to the bicycle
(Chariot Axle-Mount ezHitch)
axle-mount ezHitch and accompanying quick-release skewer.
Attaching the Axle-Mount ezHitch
The Axle-Mount ezHitch must always be attached to the
left-hand side of the bicycle.
Bicycle with quick-release axle
remove the existing quick-release. loosen the nut of the
chariot quick-release.
Push the quick-release axle through the hitch and then through
the axle of the wheel.
The opening for the hitch ball and the vertical hole for the
security pin must point forward.
Fit the quick-release nut on the right-hand side. Both skewer
springs must be located in such a way that the narrow side of
each spring points towards the centre of the hub.
warning
the quick-release nut must be tightened on the axle thread
by at least 5 full turns, so that adequate clamping force is
ensured. a thread which is too short can lead to accidental
loosening of the rear wheel which may lead to an otherwise
avoidable accident in which you and/or your passenger(s)
could suffer serious injury or death
!
!
Summary of Contents for CHEETAH 1
Page 54: ......