Attaching the skis to the carrier
Cheetah and Cougar
remove the wheels (for this, press the rubber cap in the centre
of the wheel).
to attach the skis, press the spring button in and insert the
attachment axle into the axle socket until it can go no further.
release the spring button. By moving the skis from side to side,
check that they are locked in the axle socket and cannot be
pulled off.
warning
Before each journey make sure that the skis are securely
locked in the axle socket to prevent the carrier from acci-
dentally sliding away resulting in an accident in which your
passenger(s) could suffer serious injury or death.
CX
To attach the XC Skiing Kit to the carrier, first remove the carrier
wheels.
then attach the clear protective caps over the exposed drum
brake calipers.
Pressing down the axle’s locking button, pull the axle all the
way out of the wheel hub.
Pressing down the locking button, insert the axle through the
socket at the top end of the ski frame.
make sure that you insert the axle from the outside inwards,
looking in the direction of the ski tip.
Assembly
Fitting the CX Axle Adapter Kit to the skis
If you want to use the XC Skiing Kit on the CX, you must
first convert the ski frames. For this you will need to get a
special CX Axle Adapter Kit from your authorized Chariot
retailer. Install this Adapter Kit to the skis according to the
installation instructions supplied with the kit.
warning
without conversion using the cx axle adapter Kit, the xc
skiing Kit must no be used on the cx. the standard xc ski
Kit axles will not engage fully on the cx1 and cx2, with the
result that the skis would not be held securely resulting in
an accident in which your passenger(s) could suffer serious
injury or death.
!
!
nOTE
always make sure that the ski tips point towards the front.
Summary of Contents for CHEETAH 1
Page 54: ......
