REV 41532-20120918
10
41532
ENGLISH
1 . Place the generator on a flat, level surface .
2 . Remove oil fill cap/dipstick to add oil .
3 . Add 1 .16 qt (1 .1 L) of oil (included) and replace oil
fill cap/dipstick . See “Specifications” pages for oil
recommendations based on operating conditions .
4 . Check engine oil level daily and add as needed .
The recommended oil type is 10W-30 automotive oil .
NOTE
The engine is equipped with a low-oil-shutoff and
will stop when the oil level in the crankcase falls
below the threshold level .
CAUTION
Add Engine Oil
DO NOT attempt to crank or start the engine before
it has been properly filled with the recommended
type and amount of oil . Damage to the generator as
a result of failure to follow these instructions will
void your warranty .
CAUTION
ASSEMBLy
Check oil often during the break-in period . Refer to the
Maintenance section for recommended service intervals .
NOTE
The generator rotor has a sealed, pre-lubricated ball
bearing that requires no additional lubrication for
the life of the bearing .
NOTE
Add Engine Oil Cont’d.
