3
DN
UP
1
2
3
P
S
1
A
B
C
B
D
8
2
3
4
5
6
6
7
1. Terminal Block:
used for external accessories (see chart below).
NOTE:
The terminal block is behind a plastic cover in the back housing. Use a small screwdriver to lever
open the plastic cover if access to the terminal block is required. All wires should be secured appropriately.
2. DN Button:
used to drive the door DOWN
3. UP Button:
used to drive the door UP
4. P Button:
used to “PROGRAM” the DOOR LIMITS (see section 13)
5. S Button:
used to “SAVE” the “REMOTE CONTROLS” (see section 19)
6. LEDs:
1. Program DOWN, and Diagnostic code indicator Number 1
2. Program UP indicator
3. Diagnostic code indicator Number 2
7. Control Button:
Used to activate the door when remote controls are not available. Open - Stop - Close.
8. Courtesy Light:
turns on during operation and automatically turns off after a period of 3 minutes
Ref Function
Colour Polarity
Comment
A
Push button
Red
+ve
Dry contact input for push button wired wall
controls
B
Common
White
-ve
Common terminal for push button, obstruction
detection beams & accessory power
B Common
White
-ve
Common terminal for push button, obstruction
detection beam & accessory power
C
Obstruction Detection
Beams
Grey
+ve
Obstruction detection beam eam Input (pulsing
type only) - see section 16
D
Accessory Power
Green
+ve
24v dc 50 mA accessory output available for a
universal receiver
CONTROL PANEL
4
