12
NOTE: The transmitters supplied with your
opener are preprogrammed by the factory.
If you purchase additional transmitters, the garage
door opener must be programmed to accept the new
remote code.
Program the receiver to match additional
transmitter codes:
Using the “S” SAVE Button
1.Press and hold the button on the remote that you
wish to use (1)
2.Press and release the “S” button on the opener (2)
3.Release the remote button when the courtesy light
flashes twice. It has learnt the code. If you release
the remote control push button before the opener
light flashes, the opener has not learnt the code.
The opener will now operate when the remote control
button is pressed.
To Erase all Remote Control Codes
1.Press and hold the “S” button on the opener until the
courtesy light flashes twice, and continue holding for
approximately 8 seconds, until the courtesy light
flashes twice again.
2.Release the button, all codes are now erased.
Activate the opener only when door is in full view, free of obstruction and properly adjusted.
No one should enter or leave the garage while the door is in motion. Do not allow children to
operate push buttons or remotes. Do not allow children to play near the door.
1
2
DN
UP
P
S
1
2
3
Flash
x 2
BEEP
19
WIRELESS PROGRAMMING (REMOTE ACCESSORIES)
