5
Optional UVC light shield mounting:
Head of mounting screw
cannot be located in shaded area.
Drill mounting holes
using 1/8” drill bit
(4 holes)
Drill viewport hole
using 1/4” to 1/2” drill bit
Center of
mounting base
Drill 1-1/2” diameter
Mounting template
Mount unit either
horizontal or vertical
Duct
Figure 2
Figure 3
Never expose eyes or skin to UVC light from any source. Looking directly at the UVC
light may cause permanent eye damage or blindness. Never operate the CX-Aire Air Purifying System
out of the plenum. Avoid touching the glass portion of the lamp with your hands.
WARNING
INSTALLATION
STEP 2. MOUNTING TEMPLATE OR DUCTBOARD ADAPTER PLATE (A or B)
NOTE:
If installing on sheet metal air duct, follow step A using the the supplied mounting template.
If mounting onto a fiberglass ductboard, follow step B (page 6) using the ductboard adapter plate.
Investigate and determine the location of the AC coil prior to drilling holes in duct
for mounting unit.
A. Pre-drilling with mounting template
a.
Apply supplied mounting template to air duct in either a vertical or horizontal position
(Figure 2).
b.
Drill 1⁄ 8" diameter mounting holes at positions indicated on template (Figure 3).
c.
Cut out the large opening (1-1⁄ 2" hole) on the template (Figure 3).
d.
Using a 1⁄ 4" to 1⁄ 2" drill bit, drill a viewport hole as indicated on the template (Figure 3).
NOTE:
DO NOT remove template from duct.
CAUTION
