ASSEMBLY STEPS
STEP 0
Sort all the assembly hardware.
Seriously. Many of the pieces in this kit have similar names and similar sizes. If you sort them out
into piles bolts, screws, nuts, washers, shafts, etc. then match them up by similar sizes, you
should be able to identify the ones you need at any given moment.
STEP 1
Assemble & attach the rear stabilizer.
● It’s the first part on the list [1], and the longish, oval tube in the image below. What’s the next
easiest thing to identify? How about the wheels? Attach the wheels [29] to the stabilizer using (1)
M8x45mm allen bolt [36] and (1) M8 plug [37] each.
● Next, let’s get those band peg [7] cables [48], rings [49] & pins [50] out of the way.
● While we’re thinking band pegs [7], insert the end caps [51] and M5 hex bolts [52] into them.
● Now let’s attach the leveling feet [28]. Just spin them in most not all the way.
● Snap in the end caps [26].
● Can you believe we’re ready to connect this to the base frame [2]? Grab the (2) carriage bolts
[35] and run them through the stabilizer and base frame from the bottom. Slip washers [23] over
them, then spin the nuts [24] down finger tight.
● Finally, find the square, rubber foot [39] and all (8) M6 allen bolts. Attach the foot to the bottom of
the far end of the base frame [2]. This should reduce the risk of you scratching your floor or
anything up while you’re moving things around during assembly. (Pictured in Step 3, below.)
_
V.04.29.2015
3
