STEP 3
Assemble & attach the seat/back frame.
● The image below might look like a numbers explosion, but it’s actually quite intuitive. Basically,
we’re going to connect the hinge at the base (by the stabilizer from Step 1), slip the adjustable
inner post into the sleeve, and button it up. You’ll see.
● This all revolves around the seat pad frame [3]. It’s the other big, metal piece in the kit and
should be pretty easy to find. Let’s start with the pivot end.
● Slip the 139mm shaft [10] through the end of the seat frame. Put a bushing [8] on either side,
then lower into the hinge point over the stabilizer. (1) M10x25mm bolt [32] & (1) M10 flat washer
[21] screws in from each side to secure. Tighten these and check for smooth pivot action.
_
V.04.29.2015
5
