Cessna skylance tc T182T, Information Manual

Page: 376 / 396

SECTION 9 - SUPPLEMENTS CESSNA
SUPPLEMENT 4 MODEL T182T NAV III
GFC 700 AFCS
U.S.
FAA APPROVED
NORMAL PROCEDURES
(Continued)
TO OPERATE ELAPSED TIME TIMER-COUNT UP MODE:
1. OFF/VOL Control - ON
2. FLT/ET Mode Button - PRESS (once or twice) until ET is
annunciated.
3. SET/RST Button - PRESS momentarily to reset elapsed timer to
zero.
NOTE
The Standby Frequency which is in memory while Flight
Time or Elapsed Time modes are being displayed may be
called back by pushing the FRQ button, then transferred to
active by pushing the FRQ button again.
TO OPERATE ELAPSED TIME TIMER COUNT DOWN
MODE:
1. OFF/VOL Control - ON
2. FLT/ET Mode Button - PRESS (once or twice) until ET is
annunciated.
3. SET/RST Button - PRESS until the ET annunciation begins to
flash.
4. FREQUENCY SELECTOR KNOBS - SET desired time in the
elapsed time display. The small knob is pulled out to tune the 1's.
The small knob is pushed in to tune the 10's. The outer knob
tunes minutes up to 59 minutes.
NOTE
Selector knobs remain in the time set mode for 15 seconds
after the last entry or until the SET/RST, FLT/ET or FRQ
button is pressed.
(Continued Next Page)
T182TPHBUS-S4-00
S4-10