Cessna skylance tc T182T, Information Manual

Page: 119 / 396

CESSNA SECTION 4
MODEL T182T NAV III NORMAL PROCEDURES
GFC 700 AFCS
U.S.
STARTING ENGINE (With External Power)
(Continued)
WARNING
IF M BATT AMMETER DOES NOT SHOW POSITIVE
CHARGE (+ AMPS), OR LOW VOLTS ANNUNCIATOR
DOES NOT GO OFF, REMOVE THE BATTERY FROM
THE AIRPLANE AND SERVICE OR REPLACE THE
BATTERY BEFORE FLIGHT.
29. NAV Light Switch - ON (as required)
30. AVIONICS Switch (BUS 1 and BUS 2) - ON
BEFORE TAKEOFF
1. Parking Brake - SET
2. Pilot and Passenger Seat Backs - MOST UPRIGHT POSITION
3. Seats and Seat Belts - CHECK SECURE
4. Cabin Doors - CLOSED and LOCKED
5. Flight Controls - FREE and CORRECT
6. Flight Instruments (PFD) - CHECK (no red X's)
7. Altimeters:
a.
PFD (BARO) - SET
b. Standby Altimeter - SET
8. ALT SEL - SET
9. Standby Flight Instruments - CHECK
10. Fuel Quantity - CHECK (verify level is correct)
NOTE
Flight is not recommended when both fuel quantity
indicators are in the yellow band range.
11. Mixture Control - RICH
12. FUEL SELECTOR Valve - SET BOTH
13. Autopilot - ENGAGE (push AP button on either PFD or MFD
bezel)
14. Flight Controls - CHECK (verify autopilot can be overpowered in
both pitch and roll axes)
(Continued Next Page)
T182TPHBUS-01 4-15