The build process continued
STEP 41A
Cut and connect all hoses as shown using the jubilee clips
provided.
STEP 42
The valve should remain open during normal operation.
Only close the valve off competely with pump turned off during
maintenance.
STEP 43
Connect the 3 way valve assembly to the lower suction point
as show.
STEP 44
Increase the flow rate through the skimmer by turning the
valve down.
Never turn off completely while swimmers
are in the pool
. To remove the pump lid, switch off the pump
and close the valve.
STEP 45
Fit the pre-cut Styrofoam base and tape the joints.
STEP 46
Fit the white plastic liner-lock level with the top of the timber
wall. Work your way around the pool making sure that
the liner-lock is tight into each corner. Trim the liner-lock with
a saw if necessary. Trap the foam barrier under the liner-lock.
Other end of hose
connected to the filter
multi-port valve
return to the pool
Cut and connect all hoses as shown
using the jubilee clips provided
Port can be used to drain the pool. Close valve off
first, remove plug and connect pipe and open
valve to drain.
During pool operation
the pump valve should
be left in the open
position. Only close
valve when pump is
switched off.
Liner lock
Foam barrier
