FibeAir® RFU-C
Installation Guide
Ceragon Proprietary and Confidential
Page 62 of 93
9.1
Special Note on Converting ValuLine 3 Antennas
Part numbers for ValuLine 3 antenna conversion kits are valid for most
ValuLine 3 antennas, integrated or non-integrated. These conversion kits can
also be used to convert Andrew ValuLine 3 antennas with the old Nera
Evolution interface to RFU-C. The kits support the majority of Andrew’s
ValuLine 3 antennas, 1-6ft. However, since there are some unique cases in
which Andrew provided special antennas which are not supported by these
adaptors, it is recommended that you supply your Ceragon representative
with a picture of the current antenna (back plain side), in order to confirm the
antenna’s compatibility prior to implementing this solution.
You can also check the following to determine whether the antenna is
compatible with the conversion kit:
Verify that the antenna is, in fact, a ValuLine 3 antenna.
Verify that the backplate of the antenna has in its holding plate the six
mounting holes shown in red in the figure below.
