Predator Gasser NX
Page 43
1
2
3
4
5
12
11
10
9
8
7
6
CNM3X18CS
M3
M3X10X1.5
CNBB0930
CNBB410
CNLR1013
M3X5X0.5
CNBB49T
Apply a small drop of Red
threadlock on the tail hub near
the bearing stop. Slide one M4x10
ball bearing followed by the plastic tail
rotor grip. Look carefully at the thrust bear-
ing and slide the thin race (larger inside di-
ameter) followed by the ball race, remember
to grease the ball race, followed by the thick
race (smaller inside diameter) inside the tail
grip. Slide one M3x5x0.5 micro washer and
the M3x9 ball bearing. Apply a drop of Red
threadlock to the threads and tighten the M3
locknut until the tail grip rotates smoothly with-
out binding. Repeat for the other side.
Slide one M3x18 special socket cap screw from the inside of the tail rotor grip and position
the first M3x10x1.5 spacer, insert the tail blade, another spacer and secure using one
M3 locknut from the molded recess on the outside.When correctly installed, the leading
edge of the tail rotor blades will rotate into the down wash from the main rotor blades.
Tail blade tension should be set tight enough that the rotor blade will stay straight on its
own, but will pivot easily when the blade tip is moved.
After flying the model, if a vibration is noticed on the horizontal fin, the complete
tail rotor assembly can be removed with the hub and further balanced
using a High Point balancer.
TAIL BLADE GRIP ASSEMBLY
THICK
RACE
(UPPER)
SMALLER ID
THIN RACE
(LOWER)
LARGER ID
编号
数量（PCS）
序号
1
2
3
4
1
2
5
6
7
(尾横轴)
STEEL TAIL ROTOR HUB
HW3098A
2
2
8
(轴承)
CNBB410
4x10x4 BEARING
(2mm球头螺丝)
CNLR1013
STEEL BALL, 2mm THREAD, SHORT
(尾旋翼夹片)
HI6096A
CNM3LOCK
CNM3LOCK
(螺帽)
(尾旋翼)
HI6099A
NX TAIL ROTOR BLADES
(平面垫片)
(轴承)
CNBB0930
3x9x2.5 BALL BEARING
(平面垫片)
CNLR1003
3x5x0.5 MICRO WASHER
CNBB49T
(止推轴承)
CNM3X18CS
(有头内六角螺丝)
M3x18 SOCKET HEAD CAP SCREWS
9
10
11
12
NX TAIL ROTOR GRIPS
2
2
6
(尾旋翼)
CN261056
ROTORTECH 105MM CARBON TAIL BLADES
2
2
2
2
2
2
2
4x9x4 THRUST BEARING
M3 LOCK-NUT
名称（ENGLISH-中文）
(螺帽)
M3 LOCK-NUT
CONDOR ONLY
The Condor version is supplied with:
CN261206: RotorTech 120mm Carbon Fiber Tail Blades
HW6204A
M3 X 10 X 1.5 BLADE WASHERS
