Predator Gasser NX
Page 19
1
2
3
4
5
6
CNBB1350
CNM4X4SS
The gasser kits include the regular starting shaft and hex coupler
as in all the Predator kits to align the clutch to the clutchbell.
Clean both the starting shaft and the inside race of the bear-
ing inside the clutchbell and the inside race of the top start-
ing shaft bearing. Apply a small amount of Red threadlock
positioned just above where the bottom clutchbell bear-
ing will sit on the starting shaft. Slide the starting shaft
up through the bearing blocks. Apply a small amount
of Blue threadlock to the top of the starting shaft
and slide the hex coupler in place aligning the flat
spot with one of the holes. Apply Blue thread-
lock to the the two M4x4 set screws and
tighten in place.
The hex starting system has been suc-
cessfully used with the Z231H engine
but significant wear on the hex coupler
is common. Regular replacement of the
hex coupler is normal and is not covered
by warranty. The pull start should be
used for the first start of the day. After-
wards using a heavy duty electric starter
is possible.
The clutch bell assembly and lower short
breaing block is pre-assembled. If you
notice the clutch bell and bearing block
have a loose fit, be sure to separate the
two and apply a thin coat of Red thread-
lock to the outer race of the bearing
making sure not to get the threadlock
into the inner race.
Clean the top of the pinion gear and the inside surfaces of both the upper
and lower bearings inside the clutch shaft bearing block using alcohol.
Apply a small amount of Red threadlock to the top edge of the clutch gear
where it will contact the bearing. Press the bearing block in place, firmly
seating the bearing against the top of the pinion gear.
The hex starting is not recommended for
the Z260H engine as damage can occur
to your starting equipment and helicop-
ter components.
CLUTCH BELL TO BEARING BLOCK ASSEMBLY
编号
数量（PCS）
序号
1
2
3
4
5
1
(起动轴固定座)
(轴承座)
START SHAFT BEARING BLOCK with BEARING
CNBB1350
(轴承)
5x13x4
HEX COUPLER
BALL BEARING
(轴承座)
NX / SUPER HEAVY DUTY LOWER BEARING BLOCK with BALL
BEARING
(起动轴)
HW6045HDM
HW6007M
CNM4X4SS
HW6005
CN0402
(无头内六角螺丝)
M4x4 SOCKET HEAD SET SCREW
6
1
1
1
1
2
START SHAFT
名称（ENGLISH-中文）
