Predator Gasser NX
Page 26
1
2
3
4
6
7
9
8
CCPM (cyclic collective pitch mixing) requires that the three servos that drive the swash-
plate be the same model and more importantly the same speed and torque rating. Digital
and analog servos will fly the Predator with ease as long as the minimum torque rating
selected is 70oz/in, rated at 4.8 volts. It is typical to install the elevator servo on the left
side of the frames. Having previously installed the rubber gromments and eyelets onto the
servo, install the elevator servo with its output shaft to the rear of the helicopter. Secure
using four M2.3x10 Phillips servo screws and two servo mount tabs. Continue tightening
the screws until tight, then back off 1/4 turn.
Install the four rubber gromments that
are supplied with the servo onto the servo
mounts and insert the brass eyelets so
that the flat washer side of the eyelet is
installed against the side frame. For the
elevator servo the eyelets are installed
from the top of the servo.
G10 Frames
INCLUDED
LUD
INCLUDED
LUD
SERVO ARM
2
(伺服机固定块)
HI3205
HI3205A
CNM3X8CS
1
(控制臂)
SERVO MOUNT TABS
SERVO MOUNT PLATE
(伺服机)
SERVO
STEEL BALL, 2mm THREAD, SHORT
CNLR1013
数量(PCS)
序号
1
2
3
4
5
6
1
7
8
1
1
(十字自攻螺丝)
CNM3X8ST
M3x8 PHILLIPS TAPPING SCREWS
2
2
(垫片)
4
M2.3X12 PHILLIPS SERVO SCREWS
1
(螺帽)
M3 LOCK-NUT
9
名称(ENGLISH-中文)
CNM3LOCK
M3x8 SOCKET HEAD CAP SCREWS
INSTALLING AILERON SERVO (G10)
CNM2.3X12ST
CNLR1013
M2.3X12
CNM3X8ST
M2
螺母
CNM2.3X12ST
NOT INCLUDED
NOT INCLUDED