FI002K0018v1530hUK – THS/21 Instruction manual for installation, use and maintenance
4
USE OF THE DEVICE
ORIGINAL
INSTRUCTION 165
TEST FAILED for Ejection timeout
THS/21E
THS/21
If the ejection cycle is not completed
following an alarm within a minute of
starting the test, the test is considered
to be unsuccessful.
=====================
TEST FE FAILED
EJECTION TIMEOUT
---------------------
[\\\\\\\\\\\\\\\\\\\]
TEST FE FAILED
EJECTION TIMEOUT
{|||||||||||||||||||}
Pressing any key, the display returns
to the
MD test
menu, where the
negative outcome is also shown.
FE test -0.80 NO(3)@
NFE test-1.00
SS test -1.20
3- EJECTION TIMEOUT
FE~Test~-0.80~~NO(3)@
NFE Test-1.00
SS test -1.20
3- EJECTION TIMEOUT
TEST FAILED for synchronization photocell error
THS/21E
THS/21
In the FS ejection mode, if the
synchronization photocell is not
activated following an alarm during the
test, the test is considered to be
unsuccessful.
=====================
TEST FE FAILED
SYNC PHOTOC.ERROR
---------------------
[\\\\\\\\\\\\\\\\\\\]
TEST FE FAILED
SYNC PHOTOC.ERROR
{|||||||||||||||||||}
Pressing any key, the display returns
to the
MD test
menu, where the
negative outcome is also shown.
FE test -0.80 NO(3)@
NFE test-1.00
SS test -1.20
3- SYNC PHOTOC.ERROR
FE~Test~-0.80~~NO(3)@
NFE Test-1.00
SS test -1.20
3- SYNC PHOTOC.ERROR
TEST ABORTED
If the self-diagnosis system detects a
fault of any kind, the test procedure
will be interrupted and the message
shown here will be displayed.
In this case, the “
REMOVE FAULT
CONDITIONS
” message warns that
the test cannot be repeated without
first resetting the system.
THS/21E
THS/21
=====================
TEST ABORTED
---------------------
FE~Test~-0.80~~NO(1)@
NFE Test-1.00
[\\\\\\\\\\\\\\\\\\\]
TEST ABORTED
{|||||||||||||||||||}
The test can also be interrupted by pressing P during the test.
In the event of an unsuccessful test, the “TEST FAILED” message is displayed and, if previously programmed, the fault
condition is activated. In this case you must perform a system reset before restarting the test.
4.8.2 Performing a Quick test
It is possible to run a test without having to enter the Programming mode. To do this, enable the
IN_AUX1 input through an external pushbutton connected to it (see parameter QCKT).
When you activate the input, the display will show a message requesting the test. Run the test by
passing the requested samples through the unit in the manual mode.
The result of the test will be recorded in the event log as a
Quick Test
.
