CEFLA NewTom 5G, User Manual, Page: 59 / 110

6 Scanning
6.2 Scanning a denture
6.2.1 Preliminary operations and denture positioning
Hereafter are the operations to perform to proper positioning and centering of the denture inside the
scanning area. Perform such steps according to the software instructions.
For more details about use of the patient table, please refer to the “Patient Table User Procedures”
document.
6.2.1.1 Denture positioning with patient table
1) Press the P2 button on the table console in order to reset the table to the default position.
2) Remove the head support and slide the table inside the gantry by pressing the P1 button on the
table console.
3) Insert the denture in the provided slit of the denture support, and position the support on the table
carbon fiber board as shown in the following picture. Pay attention to do not reverse the denture
(must be in the same position as in the patient mouth).
4) Finely adjust the denture position by using the table console buttons. ( UP/DOWN – LEFT/RIGHT -
FORWARD/BACK ).
In order to help the operator during the positioning of the patient the laser can be turned on by
pressing the LASER button on the scanner control panels or on the table console (required the NNT
software to be open).
5) For the denture scan please refer to Par. “Denture scan” and “Remote patient position adjustment”
included in the “Acquisition Operations with NewTom VGi-5G” document annex to the “NNT User
Manual” document .
6) Once the scan process is finished, remove the denture support from the table and press the P2
button in order to slide out the table from the gantry.
7) Place the patient head support on the on the table carbon fiber board.
NewTom 5G – User Manual 6-13